| Description |
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced.
Replacement 1. Open the glove box. 2. Press both sides of the glove box (A) and take it out.
Components Location 1. Compressor Components 1. Clutch bolt 2. Disc & Hub assembly 3. Clutch hub spacer 4. Snap ring 5. Pulley 6. Clutch magnetic coil 7.
Removal lf replacement of the rear corner radar unit bracket or extension wire is required, replace the defective part only with a new one. 1.