Hyundai Venue (QX): Manual Transmission / Good Driving Practices
- Never take the vehicle out of gear and coast down a hill. This is extremely
dangerous.
- Don't "ride" the brakes. This can cause the brakes and related parts to
overheat and malfunction. When you are driving down a long hill, slow down and
shift to a lower gear. Engine braking will help slow down the vehicle.
- Slow down before shifting to a lower gear. This will help avoid over-revving
the engine, which can cause damage.
- Slow down when you encounter cross winds. This gives you much better control
of your vehicle.
- Be sure the vehicle is completely stopped before you shift into R (Reverse)
to prevent damage to the transmission.
- Exercise extreme caution when driving on a slippery surface. Be especially
careful when braking, accelerating or shifting gears. On a slippery surface,
an abrupt change in vehicle speed can cause the drive wheels to lose traction
and may cause loss of vehicle control resulting in an accident.
WARNING
Do not use aggressive engine braking (shifting from a higher gear to a lower
gear) on slippery roads. This could cause the tires to slip and may result in an
accident.
WARNING
To reduce the risk of SERIOUS INJURY or DEATH:
- ALWAYS wear your seat belt. In a collision, an unbelted occupant is significantly
more likely to be seriously injured or killed than a properly belted occupant.
- Avoid high speeds when cornering or turning.
- Do not make quick steering wheel movements, such as sharp lane changes
or fast, sharp turns.
- The risk of rollover is greatly increased if you lose control of your
vehicle at highway speeds.
- Loss of control often occurs if two or more wheels drop off the roadway
and the driver over steers to reenter the roadway.
- In the event your vehicle leaves the roadway, do not steer sharply. Instead,
slow down before pulling back into the travel lanes.
- HYUNDAI recommends you follow all posted speed limits.
The manual transmission has 6 forward gears. The transmission is fully synchronized
in all forward gears so shifting to either a higher or a lower gear can be easily
accomplished.
Press the shift button,
then move shift lever.
Depress the brake pedal,
press the shift button, and then move shift lever.
Move shift lever.
Other information:
Component Location
1. Blower unit assembly
Component Location
1. Intake seal
2. Intake upper case
3. Intake actuator
4. Intake door
5. Intake lower case
6. Blower pad
7.
Description
Rear view camera will activate when the backup light is ON with the ignition
switch ON and the shift lever in the R position.
This system is a supplemental system that shows behind the vehicle through the
AV monitor or the ECM (Reverse Display Room Mirror) mirror while backing-up.