Hyundai Venue (QX): Interior Trim / Luggage Side Trim. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Interior Trim / Luggage Side Trim. Repair procedures

Replacement
Hyundai Venue. Luggage Side Trim. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the rear seat assembly
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Carefully remove the rear door body side weatherstrip.
3.
Carefully remove the tail gate weatherstrip.
4.
Remove the rear door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
5.
Remove the rear transverse trim.
(Refer to Interior Trim - "Rear Transverse Trim")
6.
Using a lfat-tip screwdriver and remove the luggage room lamp (A).

Hyundai Venue. Luggage Side Trim. Repair procedures
7.
Separate the luggage lamp connector and remove the luggage room lamp (A).

Hyundai Venue. Luggage Side Trim. Repair procedures
8.
Loosen the mounting screws and remove the luggage side trim (A).

Hyundai Venue. Luggage Side Trim. Repair procedures
9.
To install, reverse removal procedure.
Hyundai Venue. Luggage Side Trim. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Luggage side trim

    Component Location 1. Rear pillar trim

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Description and operation

    Description The immobilizer system will disable the vehicle unless the proper ignition key is used, in addition to the currently available anti-theft systems such as car alarms, the immobilizer system aims to drastically reduce the rate of auto theft.

    Hyundai Venue (QX) (2020-2026) Service Manual: Intake Actuator. Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding terminal 4.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0122