| Components |

| 1. Rear shock absorber 2. Dust cover 3. Spacer 4. Bumper rubber 5. Bumper rubber cover |
6. Insulator assembly 7.Washer 8. Lock nut 9. Insulator cover |
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2.
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2.
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.
Inspection 1. Loosen the cruise control switch connector. 2. Check for resistance between terminals in each switch position. Switch Connector terminal Resistance (±5%) Cancel