Hyundai Venue (QX): Suspension System / Special service tools

Special Service Tools
Tool (Number and Name)
Illustration
Use
09568-1S100
Ball joint puller

Hyundai Venue. Special service tools

Remove the ball joint from the front axle
09546-3X100
Shock absorber lock nut removal tool

Hyundai Venue. Special service tools

Used for remove the shock absorber lock nut
09551-AL100
Rear torsion beam axle bush removal / installation tool

Hyundai Venue. Special service tools

Rear torsion beam axle bush removal and installation tool

    Specifications Front Suspension Item Specification Suspension type MacPherson Strut Shock absorber  Type General Valve Rear Suspension Item Specification Suspension type Couple Torsion Beam Axle Shock absorber  Type General Valve Wheel & Tire Item Specification Wheel Steel 6.

    Troubleshooting Symptom Possible cause Remedy Hard steering Improper front wheel alignment Correct Excessive turning resistance of lower arm ball joint Replace Low tire pressure Adjust No power assist Repair and replace Poor return of steering wheel to center Improper front wheel alignment Correct Poor or rough ride Improper front wheel alignment Correct Malfunctioning shock absorber Repair or replace Broken or worn stabilizer Replace Broken or worn coil spring Replace Worn lower arm bushing Replace the lower arm assembly Abnormal tire wear Improper front wheel alignment Correct Improper tire pressure Adjust Malfunctioning shock absorber Replace Wandering Improper front wheel alignment Correct Poor turning resistance of lower arm ball joint Repair Loose or worn lower arm bushing Retighten or replace Vehicle pulls to one side Improper front wheel alignment Correct Excessive turning resistance of lower arm ball joint Replace Broken or worn coil spring Replace Bent lower arm Repair Steering wheel shimmy Improper front wheel alignment Correct Poor turning resistance of lower arm ball joint Replace Broken or worn stabilizer Replace Worn lower arm bushing Replace Malfunctioning shock absorber Replace Broken or worn coil spring Replace Bottoming Broken or worn coil spring Replace Malfunctioning shock absorber Replace Wheel / tire noise, vibration and harshness concerns are directly related to vehicle speed and are not generally affected by acceleration, coasting or decelerating.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Intake Actuator. Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding terminal 4.

    Hyundai Venue (QX) (2020-2026) Service Manual: Heater & A/C Control Unit (DATC). Repair procedures

    Self Diagnosis 1. Self-diagnosis process.    • When operating the self-diagnostics, the below fault(self-diagnostics code) will blink at 0.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.02