Hyundai Venue (QX): Engine Control System / Variable Intake Solenoid (VIS) Valve. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Engine Control / Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve. Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the VIS valve connector.
3.
Measure resistance between VIS valve terminals 1 and 2.
Specification : 30.0 - 35.0Ω [20°C (68°F)]
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
3.
Remove the ETC module.
(Refer to Engine Control System - "ETC (Electronic Throttle Control) System")
4.
Disconnect the variable intake solenoid valve connector (A).
5.
Disconnect the vacuum hose (B) from the valve.
6.
Remove the installation bolts and nut, and then remove the valve (C) from the surge tank.
Variable intake solenoid valve bracket installtion bolt :
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)

Hyundai Venue. Variable Intake Solenoid (VIS) Valve. Repair procedures
Installation
Hyundai Venue. Variable Intake Solenoid (VIS) Valve. Repair procedures   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Hyundai Venue. Variable Intake Solenoid (VIS) Valve. Repair procedures   
•
Be careful of foreign material not to flow into the valve.
1.
Install in the reverse order of removal.

    Circuit Diagram [M/T] [A/T] Harness Connector

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Mode Control Actuator. Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.

    Hyundai Venue (QX) (2020-2026) Service Manual: Description and operation

    Description The cruise control system is engaged by the cruise "ON/OFF" main switch located on right of steering wheel column. The system has the capability to cruise, coast, accelerate and resume speed. It also has a safety interrupt, engaged upon depressing brake or shifting select lever.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0141