Hyundai Venue (QX): Driveshaft Assembly / BJ Boot. Components and components location
| Components (1) |
| 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot |
5. Dynamic damper 6. Shaft 7. TJ boot band 8. TJ boot |
9. Spider assembly 10. Snap ring 11. TJ housing 12. Clip |
| Components (2) |
| 1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot |
5. Shaft 6. TJ boot band 7. TJ boot 8. Spider assembly |
9. Snap ring 10. TJ Case 11. Clip |
Disassembly • Special grease must be applied to the driveshaft joint.
Removal 1. Remove the front driveshaft. (Refer to Driveshaft Assembly - "Front Driveshaft") 2.
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Heater Unit. Components and components location
Component Location 1. Heater unit assembly Compoents 1. Mode control actuator 2. Heater core case 3. Center duct seal 4. PTC heater 5. Heater core assembly 6. Heater case [LH] 7.
Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the cool position when connecting 12V to terminal 3 and grounding terminal 7.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Repair procedures
- Engine Electrical System
- General Information
- New on site
- Most important about car
