Hyundai Venue (QX): Front Bumper / Front Bumper Cover. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Front Bumper / Front Bumper Cover. Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Loosen the front bumper upper mounting bolts.

2.	Loosen the front bumper lower mounting clips.

Loosen the mounting clips and screws on the side of front bumper (A), detach the side part of rear bumper.

•	When you pull out the front bumper, the side part of the front bumper could be damaged by the projection.

Hyundai Venue. Front Bumper Cover. Repair procedures

4.	Press the lock pin and separate the front bumper cover connector (A).

5.	Remove the front bumper cover (A).

To install, reverse removal procedure.

•	Make sure the connector is plugged in properly.

•	Replace any damaged clips (or pin-type retainers).

❮Front Bumper Cover. Components and components location

Component Location 1. Front bumper cover

Radiator Grill. Components and components location❯

Component Location 1. Radiator grill

Other information:

Hyundai Venue (QX) (2020-2026) Service Manual: Blower Motor. Repair procedures

Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation.

Hyundai Venue (QX): Front Bumper / Front Bumper Cover. Repair procedures

Other information:

Hyundai Venue (QX) (2020-2026) Service Manual: Blower Motor. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual: Cruise Control (CC) Switch. Components and components location

Categories