Hyundai Venue (QX): Heater / Heater Core. Repair procedures
| Replacement |
| 1. |
Remove the heater unit assembly.
(Refer to Heater - "Heater Unit")
|
| 2. |
Loosen the mounting screws and remove the heater core cover (A).
|
| 3. |
Loosen the mounting screws and remove the PTC heater (A).
|
| 4. |
Pull out the heater core (A) from the heater unit.
|
| 5. |
To install, reverse the removal procedure.
|
Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery / recycling / charging station.
Description The PTC (Positive Temperature Coefficient) heater is installed at the exit or the backside of heater core. The PTC heater is an electric heater using a PTC element as an auxiliary heating device that supplements deficiency of interior heat source in highly effective diesel engine.
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Antenna Coil. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the driver crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the steering column upper and lower shroud panel.
Hyundai Venue (QX) (2020-2026) Service Manual: Heater Unit. Components and components location
Component Location 1. Heater unit assembly Compoents 1. Mode control actuator 2. Heater core case 3. Center duct seal 4. PTC heater 5. Heater core assembly 6. Heater case [LH] 7.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Engine Mechanical System
- Child-Protector Rear Door Locks
- Tire Pressure Monitoring System (TPMS) (Type A)
- New on site
- Most important about car
