| Description |
| • |
Battery voltage: 12.4V or above
|
| • |
Engine : Running
|
| • |
Ambient temperature and coolant temperature
|
|
Ambient Temperature |
Coolant Temperature |
PTC Operation |
|
Below -20°C (-4°F) |
Below 75°C (167°F) |
ON |
|
10°C (50°F) |
Below 65°C (149°F) |
ON |
|
12°C (53.6°F) or above |
- |
OFF |
|
- |
80°C (176°F) or above |
OFF |

Replacement 1. Remove the heater unit assembly. (Refer to Heater - "Heater Unit") 2.
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position.
Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.
Inspection 1. Loosen the cruise control switch connector. 2. Check for resistance between terminals in each switch position. Switch Connector terminal Resistance (±5%) Cancel