Hyundai Venue: Lane Keeping Assist (LKA) / Limitations of the System
		
		
		LKA system may operate prematurely even if the vehicle does not depart from the 
intended lane, OR, LKA system may not warn you if the vehicle leaves the intended 
lane under the following circumstances:
When the lane and road conditions are poor
	- It is difficult to distinguish the lane marking from the road surface or 
	the lane marking is faded or not clearly marked.
 
	- There are markings on the road surface that look like a lane line that is 
	inadvertently being detected by the camera.
 
	- The lane line is merged or divided. (e.g. tollgate)
 
	- The lane number increases or decreases or the lane marker are crossing complicatedly.
 
	- There are more than two lane lines on the road in front of you.
 
	- The lane line is very thick or thin.
 
	- The lanes ahead are not visible due to rain, snow, water on the road, damaged 
	or stained road surface, or other factors.
 
	- The shadow is on the lane marker by a median strip, trees, etc.
 
	- The lanes are incomplete or the area is in a construction zone.
 
	- There are crosswalk signs or other symbols on the road.
 
	- The lane line in a tunnel is stained with oil, etc.
 
When external condition is intervened
	- The brightness outside changes suddenly such as when entering or exiting 
	a tunnel or passing under a bridge.
 
	- The brightness outside is too low such as when the headlamps are not on 
	at night or the vehicle is going through a tunnel or passing under a bridge.
 
	- There is a boundary structure in the roadway such as a concrete barrier, 
	guardrail and reflector post that is inadvertently being detected by the camera.
 
	- When light coming from a street light or an oncoming vehicle is reflected 
	on a wet road surface such as a puddle in the road.
 
	- The field of view in front is obstructed by sun glare.
 
	- The lane suddenly disappears such as at the intersection.
 
	- There is not enough distance between you and the vehicle in front to be 
	able to detect the lane line or the vehicle ahead is driving on the lane line.
 
	- Driving on a steep grade, over a hill, or when driving on a curved road.
 
	- The adverse road conditions cause excessive vehicle vibrations while driving.
 
	- The surrounding of the inside rear view mirror temperature is high due to 
	direct sunlight.
 
When front visibility is poor
	- The windshield or the LKA system camera lens is blocked with dirt or debris.
 
	- The windshield glass is fogged up; a clear view of the road is obstructed.
 
	- Placing objects on the dashboard, etc.
 
   
Check LKA system
If there is a problem with the system a message will appear for a few seconds. 
If the problem continues LKA system failure indicator will illuminate...
   
 
   The driver can change LKA to Lane Departure Warning system or change LKA system 
mode between Standard LKA and Active LKA from the LCD display. Go to the 'User Settings 
→ Driver Assistance → Active Lane Keeping Assist/Lane Keeping Assist/Lane Departure 
Warning...
   
 
   Other information:
   Adjusting instrument cluster illumination
When the vehicle's parking lamps or headlamps are on, press the illumination 
control button to adjust the brightness of the instrument panel illumination.
When pressing the illumination control button, the interior switch illumination 
intensity is also adjustable...
   
   When selecting a CRS for your child, always:
	Make sure the CRS has a label certifying that it meets applicable Federal 
	Motor Vehicle Safety Standards (FMVSS 213).
	Select a child restraint based on your child’s height and weight. The required 
	label or the instructions for use typically provide this information...
   
 
	 
	
        
		Categories
		
		

1. Instrument cluster
2. Horn
3. Key ignition switch/ Engine Start/Stop button
4. Infotainment system
5. Hazard warning flasher switch
read more