Hyundai Venue (QX): Auto Lighting Control System / Auto Light Sensor. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body Electrical System / Auto Lighting Control System / Auto Light Sensor. Repair procedures

Inspection
In the state of IGN1 ON, when the multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto light sensor's input.
If IGN1 ON, The BCM monitors the range of this supply and raises up a failure as soon as the supply’s voltage is out of range. Then this failure occurs and as long as this is present, the head lamp must be turned on without taking care about the sunlight level provided by the sensor.
This is designed to prevent any head lamp cut off when the failure occurs during the night.
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the photo & auto light sensor (A) from crash pad upper side by using screw (-) driver.

Hyundai Venue. Auto Light Sensor. Repair procedures
3.
Remove the auto light connector.
Installation
1.
Reconnect the auto light connector.
2.
Install the auto light sensor.

    Circuit Diagram

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: A/C Pressure Transducer. Repair procedures

    Inspection    • Before measuring the pressure of the refriferant line, check whether the refrigerant amount is charged in accordance with the specified charging amount.

    Hyundai Venue (QX) (2020-2026) Service Manual: Heater Core. Repair procedures

    Replacement 1. Remove the heater unit assembly. (Refer to Heater - "Heater Unit") 2. Loosen the mounting screws and remove the heater core cover (A). 3.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0109