| Components |

| 1. Front sub frame 2. Front axle 3. Front stabilizer bar |
4. Steering gearbox 5. Front lower arm 6. Front stabilizer bar link |
Components • Tighten with specifed torque at curb position of vehicle • Fix the strut rod end and tighten the nut 1.
Inspection 1. Check the condenser fins for clogging and damage. If clogged, clean them with water, and blow them with compressed air. If bent, gently bend them using a screwdriver or pliers. 2.
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.