| Components |

|
| 1. Lock nut cover 2. Lock nut 3. Insulator dust cap 4. Self lock nut 5. Strut insulator 6. Strut bearing 7. Spring upper seat |
8. Spring upper pad 9. Coli spring 10. Dust cover 11. Bumper rubber 12. Spring lower pad 13. Front sturt assembly |
Components 1. Front sub frame 2. Front axle 3. Front stabilizer bar 4. Steering gearbox 5. Front lower arm 6.
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2.
Oil Specification 1. The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. 2. Compressor (PAG) oil varies according to compressor model.
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.