Hyundai Venue (QX): Interior Trim / Cowl Side Trim. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Interior Trim / Cowl Side Trim. Repair procedures

Replacement
Hyundai Venue. Cowl Side Trim. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the front door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
2.
Using a flat-tip screwdriver or remover, remove the cowl side trim (A).

Hyundai Venue. Cowl Side Trim. Repair procedures
3.
To install, reverse removal procedure.
Hyundai Venue. Cowl Side Trim. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Cowl side trim

    Component Location 1. Front pillar trim

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Immobilizer Control Unit. Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box. (Refer to Body - "Glove Box Housing") 3. Remove the smart key unit (A) after loosening the nuts.

    Hyundai Venue (QX) (2020-2026) Service Manual: In-car Sensor. Description and operation

    Description The In-car air temperature sensor is built in the heater & A/C control unit. The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance value which changes in accordance with perceived inside temperature, is delivered to heater control unit and accord

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0111