| Circuit Diagram |

Components 1. Remote Control Switch (Left : Audio) 2. Remote Control Switch (Right : Cruise)
Inspection 1. Loosen the cruise control switch connector. 2. Check for resistance between terminals in each switch position.
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.