Hyundai Venue (QX): Rear Corner Radar System / Rear Corner Radar Unit. Schematic diagrams

Connector and Terminal Function

Hyundai Venue. Rear Corner Radar Unit. Schematic diagrams

[Connector A]
Pin NO
Function
1
IGN1
2
L-CAN High
3
C-CAN Low
4
Warning indicator[LH]
5
-
6
L-CAN Low
7
C-CAN High
8
Ground

[Connector B]
Pin NO
Function
1
IGN1
2
L-CAN High
3
C-CAN Low
4
Warning indicator[LH]
5
-
6
L-CAN Low
7
C-CAN High
8
Ground

Circuit Diagram

Hyundai Venue. Rear Corner Radar Unit. Schematic diagrams

    Specifications Items Blind-Spot Collision Warning (BCW) Rated voltage DC 12V Operating voltage 9V - 16V Operating speed 30 km/h - 255 km/h Sensible distance 70m Curvature radius Start : More than 100m Stop : Less than 70m Frequency 24 GHz Numbers 2EA Items Rear Cross-Traffic Collision Warning (RCCW) Rated voltage DC 12V Operating voltage 9V - 16V Operating speed 0 km/h - 10 km/h Sensible distance 25m Curvature radius - Frequency 24 GHz Numbers 2EA

    Removal    lf replacement of the rear corner radar unit bracket or extension wire is required, replace the defective part only with a new one.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Compressor. Description and operation

    Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperature refrigerant gas.

    Hyundai Venue (QX) (2020-2026) Service Manual: PTC Heater. Repair procedures

    Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.

    Categories

     
    Copyright В© 2026 www.hvenueqx.com - 0.0146