Hyundai Venue (QX): Ignition System / Description and operation

Hyundai Venue (QX) (2020-2026) Service Manual / Engine Electrical System / Ignition System / Description and operation

Description
Ignition timing is controlled by the electronic control ignition timing system.
The standard reference ignition timing data for the engine operating conditions are pre-pro grammed in the memory of the ECM (Engine Control Module).
The engine operating conditions (speed, load, warm-up condition, etc.) are detected by the various sensors. Based on these sensor signals and the ignition timing data, signals to interrupt the primary current are sent to the ECM.
The ignition coil is activated, and timing is controlled.

    On-vehicle Inspection Inspect ignition coil assembly and Perform spark test 1. Check for DTCs.    • If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: In-car Sensor. Repair procedures

    Diagnosis With GDS 1. The heating, ventilation and air conditioning can be quickly diagnosed failed parts with vehicle diagnostic system (GDS). ※ The diagnostic system (GDS) provides the following information.

    Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the cool position when connecting 12V to terminal 3 and grounding terminal 7.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0126