Hyundai Venue (QX): Ignition System / Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Engine Electrical System / Ignition System / Repair procedures

On-vehicle Inspection
Inspect ignition coil assembly and Perform spark test
1.
Check for DTCs.
Hyundai Venue. Repair procedures   
•
If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to DTC guide)
2.
Check if sparks occur.
(1)
Remove the engine cover.
(2)
Remove the ignition coils.
(3)
Using a spark plug wrench, remove the spark plugs.
(4)
Disconnect the 4 injector connectors.
(5)
Ground the spark plug to the engine.

Hyundai Venue. Repair procedures
(6)
Check if sparks occur at each spark plug while engine is being cranked.
Hyundai Venue. Repair procedures   
•
Do not crank the engine for more then 5 seonds.
3.
If sparks do not occur, perform the following test.

Hyundai Venue. Repair procedures
4.
Using a spark plug wrench, install spark plugs.
5.
Install the ignition coils.
6.
Install the cylinder head center cover and the engine cover.

    Description Ignition timing is controlled by the electronic control ignition timing system. The standard reference ignition timing data for the engine operating conditions are pre-pro grammed in the memory of the ECM (Engine Control Module).

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Warning Indicator. Repair procedures

    Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim. (Refer to Body - "Front door trim") 3. Disconnect the power door mirror connector from the harness 4.

    Hyundai Venue (QX) (2020-2026) Service Manual: Troubleshooting

    Trouble Symptom Charts Trouble Symptom 1 Trouble Symptom 2 Trouble symptom Probable cause Remedy The set vehicle speed varies greatly upward or downward "Surging" (repeated alternating acceleration and deceleration) occurs after setti

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0188