Hyundai Venue (QX): Cylinder Block / Flywheel. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Engine Mechanical System / Cylinder Block / Flywheel. Repair procedures

Removal and installation
1.
Remove the manual transaxle.
(Refer to Manual Transaxle System - "Manual Transaxle")
2.
Remove the flywheel (A).
Tightening torque :
71.6 - 75.5 N.m (7.3 - 7.7 kgf.m, 52.8 - 55.6 lb-ft)

Hyundai Venue. Flywheel. Repair procedures
3.
Install in the reverse order of removal.

    Components 1. Fly Wheel

    Components 1. Rear oil seal

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Repair procedures

    Inspection The following section describes how to diagnose faults using a diagnostic instrument. 1. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS.

    Hyundai Venue (QX) (2020-2026) Service Manual: Evaporator Temperature Sensor. Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the evaporator temperature sensor connector. 3. Measure the resistance between terminal "+" and "-" of the evaporator temperature sensor.

    Categories

     
    Copyright В© 2026 www.hvenueqx.com - 0.0218