| Components |

| 1. Rear oil seal |
Removal and installation 1. Remove the manual transaxle. (Refer to Manual Transaxle System - "Manual Transaxle") 2.
Components 1. Piston ring (#1) 2. Piston ring (#2) 3. Oil ring 4. Piston 5. Piston pin 6. Connecting rod 7.
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater unit assembly. (Refer to Heater - "Heater Unit") 3. Separate the evaporator temperature sensor connector (A), loosen the mounting screws and remove the eva
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.