Hyundai Venue (QX): Front Seat / Front Seat Assembly. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Assembly. Repair procedures

Replacement
1.
Loosen the front seat mounting bolts.
[Front]
Tightening torque :
49.0 - 63.7 N.m (5.0 - 6.5 kgf.m, 36.2 - 47.0 lb-ft)

Hyundai Venue. Front Seat Assembly. Repair procedures

[Rear]

Hyundai Venue. Front Seat Assembly. Repair procedures
2.
Separate the front seat main connector (A), side airbag connector (B) and front seat belt buckle connector (C).

Hyundai Venue. Front Seat Assembly. Repair procedures
3.
To install, reverse removal procedure.
Hyundai Venue. Front Seat Assembly. Repair procedures   
The installation procedures of seat mounting bolts
•
Push the seat to the rear end of slides and initially tighten the front mounting bolts.
•
Push the seat to the front end of slides and completely tighten the rear mounting bolts.
•
Send the seat to the rear end again to completely tighten the front mounting bolts.
•
Check the seat for smooth movement.
•
For the non-automatic slide seats, check the seats are fixed at each designated fixing position.

    Component Location 1. Front seat headrest 2. Front seat back cover 3. Front seat cushion cover

    Component Location 1. Front seat shield outer cover

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Blower Resistor (Manual). Repair procedures

    Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.

    Hyundai Venue (QX) (2020-2026) Service Manual: Rear Corner Radar Unit. Repair procedures

    Removal    lf replacement of the rear corner radar unit bracket or extension wire is required, replace the defective part only with a new one. 1.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0134