Hyundai Venue (QX): Front Seat Belt / Front Seat Belt Pretensioner. Repair procedures

Replacement
Hyundai Venue. Front Seat Belt Pretensioner. Repair procedures   
•
When installing the belt, make sure not to damage the pretensioner.
1.
Loosen the mounting bolt and remove the front seat belt lower anchor (A).
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)

Hyundai Venue. Front Seat Belt Pretensioner. Repair procedures

2.
Remove the center pillar lower trim.
(Refer to Interior Trim - "Center Pillar Trim")
3.
Remove the center pillar upper trim.
(Refer to Interior Trim - "Center Pillar Trim")
4.
Loosen the mounting bolt and remove the front belt upper anchor (A).
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)

Hyundai Venue. Front Seat Belt Pretensioner. Repair procedures

5.
Separate the pretensioner, airbag connector (A), loosen the mounting bolts and remove the front seat belt pretensioner (B).
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)

Hyundai Venue. Front Seat Belt Pretensioner. Repair procedures

6.
To install, reverse removal procedure.
Hyundai Venue. Front Seat Belt Pretensioner. Repair procedures   
•
After installing the front seat belt retractor, check that the air bag warning indicator illuminates for about 6 seconds when the ignition is ON and then goes out.
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Front Seat Belt Pretensioner

    Component Location 1. Height adjust

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: In-car Sensor. Description and operation

    Description The In-car air temperature sensor is built in the heater & A/C control unit. The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance value which changes in accordance with perceived inside temperature, is delivered to heater control unit and accord

    Hyundai Venue (QX) (2020-2026) Service Manual: Heater & A/C Control Unit (DATC). Repair procedures

    Self Diagnosis 1. Self-diagnosis process.    • When operating the self-diagnostics, the below fault(self-diagnostics code) will blink at 0.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0091