Hyundai Venue (QX): Front View Camera System / Front View Camera Unit. Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front view camera cover (A).

Hyundai Venue. Front View Camera Unit. Repair procedures

3.
Separate the front view camera connector (A).

Hyundai Venue. Front View Camera Unit. Repair procedures

4.
After passing the fixing point (B) of the coupler, remove the front view camera (A).

Hyundai Venue. Front View Camera Unit. Repair procedures

Hyundai Venue. Front View Camera Unit. Repair procedures   
•
Be careful not to break any of the anchor points (B).
Installation
1.
Install in the reverse order of removal.
2.
When if replacing the front view camera with a new one, perform the "Variant Coding" procedure by using the Diagnostic Tools.

Hyundai Venue. Front View Camera Unit. Repair procedures

3.
Perform the front view camera unit calibration.
(Refer to Repair procedures - "Service Point Target Auto Calibration (SPTAC)")

    Circuit Diagram

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: PTC Heater. Repair procedures

    Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.

    Hyundai Venue (QX) (2020-2026) Service Manual: Heater & A/C Control Unit (DATC). Repair procedures

    Self Diagnosis 1. Self-diagnosis process.    • When operating the self-diagnostics, the below fault(self-diagnostics code) will blink at 0.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0177