| Replacement |
| 1. |
Remove the luggage covering bord (A).
|
| 2. |
Loosen the mounting bolts and remove the rear seat cushion assembly
(A).
|
| 3. |
To install, reverse the removal procedure.
|
| 1. |
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
|
| 2. |
Pull up the rear seat back assembly (A) by pulling the stand-up lever.
|
| 3. |
Loosen the mounting bolt and remove the rear seat back assembly (A).
|
| 4. |
To install, reverse removal procedure.
|
Component Location 1. Rear seat cushion assembly 2. Rear seat back assembly
Component Location 1. Rear seat back cover [LH] 2. Rear seat back cover [RH]
Inspection The following section describes how to diagnose faults using a diagnostic instrument. 1. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS.
Oil Specification 1. The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. 2. Compressor (PAG) oil varies according to compressor model.