Hyundai Venue (QX): Lift and Support Points / General information

Hyundai Venue (QX) (2020-2026) Service Manual / General Information / Lift and Support Points / General information

Lift and Support Points
Hyundai Venue. General information   
•
When heavy rear components such as suspension, fuel tank, spare tire, tailgate and trunk lid are to be removed, place additional weight in the luggage area before hoisting. When substantial weight is removed from the rear of the vehicle, the center of gravity may change and can cause the vehicle to tip forward on the hoist.
Hyundai Venue. General information   
•
With each tire/wheel assembly weighing approximately 30lbs (14kg), placing the front wheels in the luggage area can help the weight distribution.
•
Use the same support points to support the vehicle on safety stands.
1.
Place the lift blocks under the support points as shown in the illustration.
2.
Raise the hoist a few inches (centimeters) and rock the vehicle to make sure that the vehicle is firmly supported.
3.
Raise the hoist to full height to check whether the vehicle is firmly supported.

Hyundai Venue. General information

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Evaporator Temperature Sensor. Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the evaporator temperature sensor connector. 3. Measure the resistance between terminal "+" and "-" of the evaporator temperature sensor.

    Hyundai Venue (QX) (2020-2026) Service Manual: Warning Indicator. Components and components location

    Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim. (Refer to Body - "Front door trim") 3. Disconnect the power door mirror connector from the harness 4.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0177