| Replacement |
| 1. |
Using a flat-tip screwdriver and remove the front door quadrant inner
cover (A).
|
| 2. |
Separate the outside rear view mirror connector (A), loosen the mounting
nuts and remove the outside rear view mirror (B).
|
| 3. |
To install, reverse removal procedure.
|
Component Location 1. Outside rear view mirror
Component Location 1. Inside rear view mirror
Inspection 1. Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column. 2. Check for continuity between the terminals. 3.
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.