Hyundai Venue (QX): Air Conditioning System / Ambient Temperature Sensor. Description and operation

Description
The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature.
The sensor output will be used for discharge temperature control, temperature regulation door control, blower motor level control, mix mode control and in-car humidity control.

Hyundai Venue. Ambient Temperature Sensor. Description and operation

Hyundai Venue. Ambient Temperature Sensor. Description and operation   
If the ambient temperature is below 2.0°C (35.6°F), the A/C compressor will stop.
The compressor will operate manually.

    Description The photo sensor is located at the center of the defrost nozzles. The photo sensor contains a photovoltaic (sensitive to sunlight) diode.

    Inspection 1. Check the resistance of the ambient temperature sensor between terminals 1 and 2 whether it changes by changing the ambient temperature.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Start/Stop Button. Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crashpad lower panel. (Refer to BODY - "Crashpad Lower Panel") 3. Disconnect the SSB connector (A).

    Hyundai Venue (QX) (2020-2026) Service Manual: Rear Corner Radar Unit. Repair procedures

    Removal    lf replacement of the rear corner radar unit bracket or extension wire is required, replace the defective part only with a new one. 1.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.011