Hyundai Venue (QX): Front Suspension System / Rear Coil Spring. Repair procedures

Removal
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from the rear hub.
Tightening torque :
107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft)
Hyundai Venue. Rear Coil Spring. Repair procedures   
•
Be careful not to damage the hub bolts when removing the rear wheel and tire (A).

Hyundai Venue. Rear Coil Spring. Repair procedures

3.
Loosen the bolt and then discoonect the rear shock absorber (A) from the torsion beam axle.
Tightening torque :
98.1 - 117.7N.m (10.0 - 12.0kgf.m, 72.3 - 86.8lb-ft)
[LH]

Hyundai Venue. Rear Coil Spring. Repair procedures

[RH]

Hyundai Venue. Rear Coil Spring. Repair procedures

4.
Remove the coil spring (A).

Hyundai Venue. Rear Coil Spring. Repair procedures

Inspection
1.
Check the coil spring for crack and deformation.
2.
Check the coil spring pad for damage and deformation.
Installation
1.
Install in the reverse order of removal.

    Components 1. Coil spring upper pad 2. Rear coil spring 3. Coil spring lower pad

    Components Location 1. Torsion beam axle

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Heater Core. Repair procedures

    Replacement 1. Remove the heater unit assembly. (Refer to Heater - "Heater Unit") 2. Loosen the mounting screws and remove the heater core cover (A). 3.

    Hyundai Venue (QX) (2020-2026) Service Manual: Description and operation

    Description Rear Corner Radar is a system that measures the relative speed and distance from the following vehicles by using two electromagnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0168