Hyundai Venue (QX): Rear Door / Rear Door Latch. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Latch. Repair procedures

Replacement
Hyundai Venue. Rear Door Latch. Repair procedures   
•
When removing with a flat-tip screwdriver or remover,wrap protective tape around the tools to preventdamage to components.
•
Take care not to scratch the body surface.
1.
Remove the rear door module.
(Refer to Rear Door - "Rear Door Module")
2.
Separate the rear door outside handle connector (A) and loosen the mounting clips.

Hyundai Venue. Rear Door Latch. Repair procedures
3.
Loosen the mounting bolt, remove the rear door inside handle case (A) and rubber packing (B).

Hyundai Venue. Rear Door Latch. Repair procedures
4.
Remove the front door latch (A) by gently lifting the locking pin (B).

Hyundai Venue. Rear Door Latch. Repair procedures
5.
Open the cover to remove the rod (A) and remove the front door outside handle base (B).

Hyundai Venue. Rear Door Latch. Repair procedures
6.
To install, reverse removal procedure.
Hyundai Venue. Rear Door Latch. Repair procedures   
•
Make sure the connector is connected properly.
•
Make sure the door locks / unlocks and opens / closes properly.
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Rear door latch

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Compressor. Repair procedures

    Removal    Precautions for using the plastic pulley • Be careful not to place the pulley to downwards of the floor or table.

    Hyundai Venue (QX) (2020-2026) Service Manual: Intake Actuator. Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding terminal 4.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0199