Hyundai Venue (QX): Interior Trim / Rear Pillar Trim. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Interior Trim / Rear Pillar Trim. Repair procedures

Replacement
Hyundai Venue. Rear Pillar Trim. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the luggage side trim.
(Refer to Interior Trim - "Luggage Side Trim")
2.
Using a flat-tip screwdriver and remove the rear pillar trim (A).

Hyundai Venue. Rear Pillar Trim. Repair procedures
3.
To install, reverse removal procedure.
Hyundai Venue. Rear Pillar Trim. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Rear pillar trim

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: A/C Pressure Transducer. Repair procedures

    Inspection    • Before measuring the pressure of the refriferant line, check whether the refrigerant amount is charged in accordance with the specified charging amount.

    Hyundai Venue (QX) (2020-2026) Service Manual: Mode Control Actuator. Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0213