Hyundai Venue (QX): Rear Seat Belt / Rear Seat Belt Retractor. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Rear Seat Belt / Rear Seat Belt Retractor. Repair procedures

Replacement
Hyundai Venue. Rear Seat Belt Retractor. Repair procedures   
•
When installing the belt, make sure not to damage the pretensioner.
1.
Remove the rear seat assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Remove the luggage side trim.
(Refer to Interior Trim - "Luggage Side Trim")
3.
Remove the rear pillar trim.
(Refer to Interior Trim - "Rear Pillar Trim")
4.
Loosen the mounting bolts and remove the second row seat belt retractor (A).
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)
[RH]

Hyundai Venue. Rear Seat Belt Retractor. Repair procedures

[LH]

Hyundai Venue. Rear Seat Belt Retractor. Repair procedures
5.
To install, reverse removal procedure.

    Component Location 1. Rear seat belt retractor

    Component Location 1. Rear center seat belt retractor

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Compressor. Description and operation

    Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperature refrigerant gas.

    Hyundai Venue (QX) (2020-2026) Service Manual: Evaporator Temperature Sensor. Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the evaporator temperature sensor connector. 3. Measure the resistance between terminal "+" and "-" of the evaporator temperature sensor.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0115