Hyundai Venue (QX): Air Conditioning System / Receiver-Drier. Repair procedures
| Replacement |
| 1. |
Remove the condenser.
|
| 2. |
Remove the cap (A) on the bottom of the condenser with a L wrench.
|
| 3. |
Remove the receiver-drier (A) from condenser using a long nose plier.
Check for crumbled receiver-drier and clogged bottom cap filter.
|
| 4. |
Apply air conditioning compressor oil along the O-rings and threads
of the new bottom cap.
|
| 5. |
Insert a new receiver-drier into the receiver drier tank. The receiver-drier
must be sealed in vacuum before it is exposed to air for use.
|
| 6. |
Install a new bottom cap to the condenser.
|
Inspection 1. Check the condenser fins for clogging and damage. If clogged, clean them with water, and blow them with compressed air.
Description The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it.
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Description and operation
Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.
Hyundai Venue (QX) (2020-2026) Service Manual: Heater & A/C Control Unit (DATC). Repair procedures
Self Diagnosis 1. Self-diagnosis process. • When operating the self-diagnostics, the below fault(self-diagnostics code) will blink at 0.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Engine Electrical System
- Vehicle Information
- Convenient Features
- New on site
- Most important about car
