Hyundai Venue (QX): Sunroof / Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Sunroof / Repair procedures

Adjustment
Inspect Glass Alignment
1.
Inspect the step height between the roof panel (A) and the glass weatherstrip (B) and then adjust it if necessary.
Alignment adjustment
Standard value [mm(in.)]
(1) Front edge : 0 mm (0 in.)
(2) Rear edge : 0 mm (0 in.)
(3) Side edge : 0 mm (0 in.)

Hyundai Venue. Repair procedures
2.
Adjust the height of the glass by slighly loosening the screws (A).

Hyundai Venue. Repair procedures
When To Initialize The Motor
3.
After initial vehicle assembly.
4.
If the initial value is erased or damaged because of short power electric discharge during operation.
5.
After using the manual handle.
Operating The Sunroof Emergency Handle
6.
Use the sunroof emergency handle to close or open the sunroof manually if the sunroof cannot be closed electronically due to motor or controller electrical malfunction.

Hyundai Venue. Repair procedures
7.
If needed, initialize the sunroof according to the initialization method.
Whenever the vehicle battery is disconnected or discharged, or you use the emergency handle to operate the sunroof, you have to reset your sunroof system as follows :
(1)
Turn the ignition key to the ON position and then close the sunroof completely.
(2)
Release the sunroof control lever.
(3)
Press and hold the CLOSE button for more than 10 seconds until the sunroof closed and it has moved slightly.
(4)
Release the sunroof control lever.
(5)
Press and hold the CLOSE button once again until the sunroof do as follows
•
Tilt up a slide open a slide close.
Then release the lever.
(6)
Reset procedure of sunroof system is finished.

    Components 1. Extension wire 2. Sunshade assembly 3. Motor assembly 4. Mechanism assembly 5. Frame sub assembly 6.

    Components Location 1. Sunroof glass

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Special service tools

    Special Service Tools Tool (Number and name) Illustration Use 09977-3R000 Disc & hub assembly bolt remover Removal and installation of disc & hub assembly.

    Hyundai Venue (QX) (2020-2026) Service Manual: Description and operation

    System Overview Parkin Distance Warning (PDW) is an electronic driving aid that warns the driver to be cautious while parking or driving at low speed. The sensor uses ultrasonic waves to detect objects within proximity of the vehicle.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.018