Hyundai Venue (QX): Trunk Trim / Repair procedures

Replacement
Hyundai Venue. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the rear seat assembly
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Carefully remove the rear door body side weatherstrip.
3.
Carefully remove the tail gate weatherstrip.
4.
Remove the rear door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
5.
Remove the rear transverse trim.
(Refer to Interior Trim - "Rear Transverse Trim")
6.
Using a lfat-tip screwdriver and remove the luggage room lamp (A).

Hyundai Venue. Repair procedures

7.
Separate the luggage lamp connector and remove the luggage room lamp (A).

Hyundai Venue. Repair procedures

8.
Loosen the mounting screws and remove the luggage side trim (A).

Hyundai Venue. Repair procedures

9.
To install, reverse removal procedure.
Hyundai Venue. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Components 1. Luggage side trim [LH] 2. Rear transverse trim 3. Luggage board assembly 4. Luggage side trim [RH] 5.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Components and components location

    Component Location [Engine Room] 1. Condenser 2. Discharge hose 3. Suction & Liquid tube assembly 4. Compressor 5. Service port (High pressure) 6. A/C Pressure transducer (APT) 7. Service port (Low pressure) 8.

    Hyundai Venue (QX) (2020-2026) Service Manual: Cruise Control (CC) Switch. Repair procedures

    Inspection 1. Loosen the cruise control switch connector. 2. Check for resistance between terminals in each switch position. Switch Connector terminal Resistance (±5%) Cancel

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.017