| Inspection |
| 1. |
Check for continuity and measure the resistance between terminals No
3 and No 6.
|
| 2. |
Operate the seat heater after connecting the connector, and then check
the thermostat by measuring the temperature of seat surface.
|
| Removal |
| 1. |
Remove the passenger seat.
(Refer to Body - "Front Seat Assembly")
|
| 2. |
Disconnect the connector (A) and then remove the seat heater unit (B).
|
| 1. |
Remove the passenger seat.
(Refer to Body - "Front Seat Assembly")
|
| 2. |
Remove the front seat cushion/ back cover.
(Refer to Body - "Front Seat Back Cover")
(Refer to Body - "Front Seat Cushion Cover")
|
| 3. |
Disconnect the heater pad from front seat cushion/back.
[Cushion]
[Back]
|
| Installation |
| 1. |
Install the seat heater unit.
|
| 2. |
Install the passenger seat assembly.
|
| 1. |
Install the seat cushion/back heater pad.
|
| 2. |
Install the seat cushion/back cover.
|
| 3. |
Install the front seat assembly.
|
Circuit Diagram [Front Seat Heater] NO Description 1 ECU Battery(+) 2 ECU Battery(+) 3 Passenger heater power 4 Passenger NTC (+) 5 Passenger heater indicator (Low) 6 - 7 Passenger heater indicator (High) 8 - 9 ILL (-) 10 Passenger heater switch 11 Passenger NTC (-) 12 Passenger heater GND 13 ECU GND 14 IGN 1 15 IGN 2 16 Drive heater power 17 Drive NTC (+) 18 Drive heater indicator (Low) 19 - 20 Drive heater indicator (High) 21 - 22 DETENT 23 Drive heater switch 24 Drive NTC (-) 25 Drive heater GND 26 ECU GND
Components [Front Seat] 1. Driver seat heater switch 2. Passenger seat heater switch
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel (A). (Refer to Body - "Crash Pad Lower Panel") 3. Remove the crash pad lower switch (A).
Description Rear Corner Radar is a system that measures the relative speed and distance from the following vehicles by using two electromagnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm.