Hyundai Venue (QX): Heater / Temperature Control Actuator. Description and operation
Hyundai Venue (QX) (2020-2026) Service Manual / Heating, Ventilation and Air Conditioning / Heater / Temperature Control Actuator. Description and operation
| Description |
The temperature control actuator is located at the heater unit. It regulates
the temperature by the procedure as follows.
The signal from the control unit adjusts the position of the temperature door
by operating the temperature switch. Then the temperature will be regulated
by the hot/cold air ratio decided by the position of the temperature door.
Components Location 1. Temperature control actuator
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector.
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Refrigerant Line. Repair procedures
Replacement 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative (-) battery terminal.
Hyundai Venue (QX) (2020-2026) Service Manual: A/C Pressure Transducer. Description and operation
Description The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by operating it high speed or low speed.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Operating Door Locks from Outside the Vehicle
- Vehicle Information
- Engine Mechanical System
- New on site
- Most important about car
Copyright В© 2026 www.hvenueqx.com - 0.0157