Hyundai Venue: Lighting System / Specifications

Hyundai Venue (QX) (2020-2024) Service Manual / Body Electrical System / Lighting System / Specifications

Specifications

Items			Bulb Type	Bulb Wattage (W)
Front	Head lamp	General (Low/High)	9005HL+	55 / 60
	Head lamp	Option (Low/High)	9005HL+	60
	Turn signal lamp		PY21W	21
	Static bending light (SBL)		H7	55
	DRL/Position lamp (General)		PY21/5W	21/5
	DRL/Position lamp (Option)		LED	LED
Rear	Rear combination lmap (General)	Turn signal lamp	PY21W	21
	Rear combination lmap (General)	Stop / Tail lamp	P21/ 5W	21/ 5
	Rear combination lmap (Option)	Stop/Tail lamp	LED	LED
	Rear combination lmap (Option)	Turn signal lamp	PY21W	21
	High mounted stop lamp		W16W	16
License plate lamp			W5W	5
Overhead console lamp			FESTOON	10
Room lamp			FESTOON	8
Back up lamp			W16W	16

Lighting System

Components and components location

Component Location 1. Head Lamp (Low, High) 2. DRL/Position lamp 3. Static bending light (SBL) 4. DRL & Position Lamp 5...

Other information:

Hyundai Venue (QX) (2020-2024) Service Manual: Troubleshooting

Troubleshooting Symptom Passible Cause Remedy (Refer to page) Water leaks from sunroof Deteriorated roof lid weatherstrip Replace Excessive roof lid-to-body clearance and improperly fitted weatherstrip Adjust Wind noise around sunroof Loose or deformed deflector, gaps in body work Retighten adjust or replace Noise created by moving sunroof lid Foreign particles lodged in guide rail Check drive cable and guide rails for foreign particles Loose guide rails and lid Retighten Motor runs but sunroof does not move or moves only partially Foreign particles lodged in guide rail Adjust or replace Incorrect engagement of motor pinion with drive cable Decrease in motor's clutch slipping force Increased sunroof sliding resistance or interference of sunroof with drive cables, weatherstrip, etc...

Hyundai Venue (QX) (2020-2024) Service Manual: Water pump. Repair procedures

Removal 1. Drain the coolant. (Refer to Cooling System - "Coolant") 2. Remove the drive belt. (Refer to Timing System - "Drive Belt") 3...

Categories

Air bag collision sensors

WARNING

To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:

Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Do not install bumper guards or replace the bumper with a nongenuine HYUNDAI parts. This may adversely affect the collision and air bag deployment performance. Place the ignition switch in the LOCK/OFF or ACC position when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs conducted by an authorized HYUNDAI dealer.

Hyundai Venue. Air bag collision sensors