Hyundai Venue: Ignition Lock Switch / Clutch Switch. Specifications
Item
|
Specifications
|
Working voltage
|
DC 12.5V ± 0.3V
|
Operating force
|
Initial position : 0.25 ± 0.15N(0.025 ± 0.015kg, 0.056 ± 0.034lb)
|
Full position : 0.8 ± 0.2 N(0.08 ± 0.02 kgf, 0.180 ± 0.045 lb)
|
Working temperature
|
-40°C ~ 80°C (-104°F ~ 176°F)
|
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the crash pad lower panel...
Description
–
Clutch operation is detected through clutch switch signal. This signal
enables ECM to cope with instant change of load condition...
Other information:
Inspection
•
Refer to the DTC manual for the check procedure.
Removal
•
When the solenoid valve Diagnostic Trouble Codes (DTC) is on,
perform the following procedure to replace it...
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery / recycling / charging station.
3.
When the engine is cool, drain the engine coolant from the radiator...
Categories
Seat belt warning light (for driver’s seat)

As a reminder to the driver, the seat belt warning light will illuminate for
approximately 6 seconds each time you place the ignition switch to the ON position
regardless of belt fastening. However, if the seat belt is unfasted, a warning chime
will sound for approximately 6 seconds.
read more