Hyundai Venue (QX): Crankshaft Position Sensor (CKPS) / Description and operation
Hyundai Venue (QX) (2020-2026) Service Manual / Engine Control / Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS) / Description and operation
| Description |
Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one
of the most important sensors of the engine control system. If there is no CKPS
signal input, fuel is not supplied.That is, vehicle can't run without CKPS signal.
This sensor is installed on the cylinder block or the transaxle housing and
generates alternating current by magnetic flux field which is made by the sensor
and the target wheel when engine runs.
The target wheel consists of 58 slots and 2 missing slots on 360 degrees CA
(Crank Angle).
Specification Item Specification Coil Resistance (Ω) 774 - 946 [20°C (68°F)] pin 2
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: PTC Heater. Repair procedures
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.
Hyundai Venue (QX) (2020-2026) Service Manual: Cruise Control (CC) Switch. Components and components location
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Engine Electrical System
- Engine Mechanical System
- Repair procedures
- New on site
- Most important about car
Copyright © 2026 www.hvenueqx.com - 0.0177