Hyundai Venue (QX): Engine Control / Fuel System
- Specifications
- Special service tools
- Troubleshooting
- Engine Control System
- Components and components location
- Description and operation
- Engine Control Module (ECM). Schematic diagrams
- Engine Control Module (ECM). Repair procedures
- ETC (Electronic Throttle control) System
- Manifold Absolute Pressure Sensor (MAPS)
- Intake Air Temperature Sensor (IATS)
- Engine Coolant Temperature Sensor (ECTS). Description and operation
- Engine Coolant Temperature Sensor (ECTS). Specifications
- Engine Coolant Temperature Sensor (ECTS). Schematic diagrams
- Engine Coolant Temperature Sensor (ECTS). Repair procedures
- Crankshaft Position Sensor (CKPS)
- Camshaft Position Sensor (CMPS). Description and operation
- Camshaft Position Sensor (CMPS). Troubleshooting
- Camshaft Position Sensor (CMPS). Schematic diagrams
- Camshaft Position Sensor (CMPS). Repair procedures
- Knock Sensor (KS). Description and operation
- Knock Sensor (KS). Specifications
- Knock Sensor (KS). Schematic diagrams
- Knock Sensor (KS). Repair procedures
- Heated Oxygen Sensor (HO2S)
- Accelerator Position Sensor (APS). Description and operation
- Accelerator Position Sensor (APS). Specifications
- Accelerator Position Sensor (APS). Schematic diagrams
- Accelerator Position Sensor (APS). Repair procedures
- Injector. Description and operation
- Injector. Specifications
- Injector. Schematic diagrams
- Injector. Repair procedures
- Purge Control Solenoid Valve (PCSV). Description and operation
- Purge Control Solenoid Valve (PCSV). Specifications
- Purge Control Solenoid Valve (PCSV). Schematic diagrams
- Purge Control Solenoid Valve (PCSV). Repair procedures
- CVVT Oil Control Valve (OCV). Description and operation
- CVVT Oil Control Valve (OCV). Specifications
- CVVT Oil Control Valve (OCV). Schematic diagrams
- CVVT Oil Control Valve (OCV). Repair procedures
- Variable Intake Solenoid (VIS) Valve. Description and operation
- Variable Intake Solenoid (VIS) Valve. Schematic diagrams
- Variable Intake Solenoid (VIS) Valve. Repair procedures
- Fuel Delivery System
- Components and components location
- Fuel pressure test
- Release residual pressure in fuel line
- Fuel Tank. Repair procedures
- Fuel Pump. Repair procedures
- Fuel Filter. Repair procedures
- Fuel Pump Motor. Repair procedures
- Fuel Sender. Repair procedures
- Fuel Pressure Regulator. Repair procedures
- Fuel Line. Repair procedures
- Filler-Neck Assembly. Repair procedures
- Accelerator Pedal. Repair procedures
- Delivery Pipe. Repair procedures
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine speed and load.
Specifications Fuel Delivery System Items Specification Fuel Tank Capacity 45 lit (11.
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Refrigerant Line. Repair procedures
Replacement 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative (-) battery terminal.
Hyundai Venue (QX) (2020-2026) Service Manual: PTC Heater. Repair procedures
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Rear Seat Assembly. Repair procedures
- Maintenance
- Engine Coolant
- New on site
- Most important about car
