Hyundai Venue (QX): General Information / General Tightening Torque Table

Tightening Torque Table of Standard Parts BOLT (Nominal diameter) NUT (Nominal diameter) BOLT/NUT Normal screw Torque Nm (kg.

Other information:

Hyundai Venue (QX) (2020-2026) Service Manual: PTC Heater. Repair procedures

Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.

Hyundai Venue (QX) (2020-2026) Service Manual: Blower Unit. Repair procedures

Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery / recycling / charging station. 3. When the engine is cool, drain the engine coolant from the radiator.

Categories

 
Copyright В© 2026 www.hvenueqx.com - 0.0171