Hyundai Venue (QX): Air Conditioning System / Compressor. Description and operation

Hyundai Venue (QX) (2020-2026) Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / Compressor. Description and operation

Description
The compressor is the power unit of the A/C system.
It is located on the side of engine block and driven by a V-belt of the engine.
The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperature refrigerant gas.
Variable Swash Plate Compressor
The compressor has a swash plate that rotates to reciprocate pistons, which compress refrigerant.
The variable swash plate compressor controls the swash plate angle to change the refrigerant displacement. It achieves precise cooling capability control in accordance with vehicle interior and driving conditions.
The externally controlled variable swash plate compressor changes the swash plate angle by an ECV (Electric Control Valve) in accordance with an electrical signal from the heater & A/C control unit.
This enables stable temperature control and improved driving sensation.
ECV Control Diagram

Hyundai Venue. Compressor. Description and operation

    Replacement 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off.

    Components Location 1. Compressor Components 1. Clutch bolt 2. Disc & Hub assembly 3.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: In-car Sensor. Description and operation

    Description The In-car air temperature sensor is built in the heater & A/C control unit. The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance value which changes in accordance with perceived inside temperature, is delivered to heater control unit and accord

    Hyundai Venue (QX) (2020-2026) Service Manual: Mode Control Actuator. Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.

    Categories

     
    Copyright В© 2026 www.hvenueqx.com - 0.0162