Hyundai Venue: Blower / Power Mosfet. Description and operation
It is installed to the DATC and adjusts the fan rpm by precisely controlling
the voltage applied to the blower motor.
Inspection
1.
Connect the battery voltage and check the blower motor rotation.
2.
If the blower motor does not operate well, substitute with a known-good
blower motor and check for proper operation...
Inspection
1.
Measure the resistance between the terminals.
2.
The measured resistance is not within specification, the blower resistor
must be replaced...
Other information:
Inspection
•
Refer to the DTC manual for the check procedure.
Removal
•
When the solenoid valve Diagnostic Trouble Codes (DTC) is on,
perform the following procedure to replace it...
Removal and Installation
1.
Remove the automatic transaxle.
(Refer to Automatic Transaxle System - "Automatic Transaxle")
2.
Remove the drive plate(A).
Tightening torque :
71...
Categories
Vehicle Identification Number (vin)
Frame number
read more