| Component Location |

| 1. Blower unit assembly |
| Component Location |

| 1. Intake seal 2. Intake upper case 3. Intake actuator 4. Intake door 5. Intake lower case 6. Blower pad |
7. Blower upper case 8. Climate air filter 9. Power mosfet 10. Resistor 11. Blower lower case 12. Blower motor |
Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery / recycling / charging station.
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crashpad lower panel. (Refer to BODY - "Crashpad Lower Panel") 3. Disconnect the SSB connector (A).
Inspection 1. Loosen the cruise control switch connector. 2. Check for resistance between terminals in each switch position. Switch Connector terminal Resistance (±5%) Cancel