Hyundai Venue (QX): Maintenance / Climate Control Air Filter

Filter Inspection

The climate control air filter should be replaced according to the Maintenance Schedule. If the vehicle is operated in severely air-polluted cities or on dusty rough roads for a long period, it should be inspected more frequently and replaced earlier. When you replace the climate control air filter, replace it performing the following procedure, and be careful to avoid damaging other components.

Hyundai Venue. Climate Control Air Filter

1. With the glove box open, push in both sides of the glove box as shown. This will ensure that the glove box stopper pins will get released from its holding location allowing the glove box to hang.

Hyundai Venue. Climate Control Air Filter

Hyundai Venue. Climate Control Air Filter

2. Open the climate control air filter cover (2) by pushing or pressing the clip (1) on the right and left side.

Hyundai Venue. Climate Control Air Filter

3. Replace the climate control air filter.

4. Reassemble in the reverse order of disassembly.

NOTICE

Install a new climate control air filter in the correct direction with the arrow symbol (↓) facing downwards, otherwise, it may be noisy and the effectiveness of the filter may be reduced.

    Filter Replacement The air cleaner filter can be cleaned for inspection using compressed air. Do not attempt to wash or to rinse it, as water will damage the filter.

    Blade Inspection Contamination of either the windshield or the wiper blades with foreign matter can reduce the effectiveness of the windshield wiper functionality.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: ESCL(Electronic Steering Column Lock). Repair procedures

    Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the steering column upper and lower shrouds.

    Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the cool position when connecting 12V to terminal 3 and grounding terminal 7.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0112