Hyundai Venue (QX): Head Lamp Leveling Device / Head Lamp Leveling Switch. Repair procedures
Hyundai Venue (QX) (2020-2026) Service Manual / Body Electrical System / Head Lamp Leveling Device / Head Lamp Leveling Switch. Repair procedures
| Inspection |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad lower panel (A).
(Refer to Body - "Crash Pad Lower Panel")
|
| 3. |
Remove the crash pad lower switch (A).
|
| 4. |
Disconnect the rheostat switch connector (A).
|
| 5. |
Operate the leveling switch, then check for continuity between terminals
of leveling switch connector.
|
Circuit diagram
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Blower Resistor (Manual). Repair procedures
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.
Hyundai Venue (QX) (2020-2026) Service Manual: Special service tools
Special Service Tools Tool Name / Number Illustration Description LKA Compensator (09890-3V100) Used for compensating front view camera unit BCW Sensor Correction Tool Set (09958-3T500) Used to correct the blin
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Repair procedures
- Operating Door Locks from Outside the Vehicle
- Tire Pressure Monitoring System (TPMS) (Type A)
- New on site
- Most important about car
Copyright В© 2026 www.hvenueqx.com - 0.0151