Hyundai Venue (QX): Crash Pad / Cluster Fascia Panel. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Crash Pad / Cluster Fascia Panel. Repair procedures

Replacement
Hyundai Venue. Cluster Fascia Panel. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Using a flat-tip screwdriver and remove the cluster fascia panel (A).

Hyundai Venue. Cluster Fascia Panel. Repair procedures
2.
To install, reverse the removal procedure.
Hyundai Venue. Cluster Fascia Panel. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Components (1) 1. Crash pad lower panel 2. Steering column shroud lower panel 3. Steering column shroud upper panel 4.

    Replacement    • Put on gloves to prevent hand injuries.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Components and components location

    Component Location [Engine Room] 1. Condenser 2. Discharge hose 3. Suction & Liquid tube assembly 4. Compressor 5. Service port (High pressure) 6. A/C Pressure transducer (APT) 7. Service port (Low pressure) 8.

    Hyundai Venue (QX) (2020-2026) Service Manual: Blower Resistor (Manual). Repair procedures

    Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0145