Hyundai Venue (QX): Timing System / Crankshaft Damper Pulley. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Engine Mechanical System / Timing System / Crankshaft Damper Pulley. Repair procedures

Removal and Installation
1.
Remove the drive belt.
(Refer to Timing System - "Dreve Belt")
2.
Remove the engineroom under cover.
3.
Remove the passenger seat RH front tire.
(Refer to Suspension System - "Wheel")
4.
Remove the crankshaft pulley (A).
Tightening torque :
46.1 - 52.0 N.m (4.7 - 5.3 kgf.m, 34.0 - 38.3 lb-ft) + 38° - 42°

Hyundai Venue. Crankshaft Damper Pulley. Repair procedures

Hyundai Venue. Crankshaft Damper Pulley. Repair procedures   
There are two methods to hold the ring gear when installing or removing the crankshaft damper pulley.
•
Install the SST (09231-2B100, 09231-3N100) to hold the ring gear after removing the starter.

Hyundai Venue. Crankshaft Damper Pulley. Repair procedures
•
Install the SST (09231-3D100) to hold the ring gear after removing the dust cover.
1)
Remove the dust cover (A) on the bottom of the ladder frame and unfasten the two transaxle mounting bolts (B).

Hyundai Venue. Crankshaft Damper Pulley. Repair procedures
2)
Adjust the length of the holder nuts (A) so that the front plate of the holder (B) puts in the ring gear (C) teeth.
3)
Adjust the angle of the links (D) so that the two transaxle mounting bolts can be fastened to the original mounted holes.

Hyundai Venue. Crankshaft Damper Pulley. Repair procedures
4)
Install the SST (09231-3D100, 09231-2W100) using the two transaxle mounting bolts and spacers. Tighten the bolts and nuts of the holder and links securely.

Hyundai Venue. Crankshaft Damper Pulley. Repair procedures
5.
Installation is reverse order of removal.
When installing the pulley, the groove on the pulley should be positioned outside.

Hyundai Venue. Crankshaft Damper Pulley. Repair procedures

    Components 1. Crankshaft damper pulley

    Components 1. Front oil seal

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Repair procedures

    Variant Coding    When you need variant coding: – Replace Front View Camera with a new one ※ EOL Variant Coding and calibration required for new replacement Front View Camera Variant Coding

    Hyundai Venue (QX) (2020-2026) Service Manual: Rear Corner Radar Unit. Repair procedures

    Removal    lf replacement of the rear corner radar unit bracket or extension wire is required, replace the defective part only with a new one. 1.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0148