Hyundai Venue (QX): Cylinder Head Assembly / Cylinder Head Cover. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Engine Mechanical System / Cylinder Head Assembly / Cylinder Head Cover. Repair procedures

Removal
1.
Remove the engine cover.
(Refer to Engine and Transaxle Assembly - "Engine Cover")
2.
Disconnect the battery negative terminal.
3.
Disconnect the ignition coil connector (A) and breather hose (B).

Hyundai Venue. Cylinder Head Cover. Repair procedures
4.
Disconnect the PCV hose (A).

Hyundai Venue. Cylinder Head Cover. Repair procedures
5.
Remove the ignition coil.
(Refer to Engine Eletrical System - "Ignition Coil")
6.
Disconnect the OCV valve connector and then remove the OCV (A).

Hyundai Venue. Cylinder Head Cover. Repair procedures
7.
Remove the cylinder head cover (A) with it`s gasket.

Hyundai Venue. Cylinder Head Cover. Repair procedures

Unfasten the cylinder head cover bolts in the seq uence shown.

Hyundai Venue. Cylinder Head Cover. Repair procedures
Installation
1.
Install the cylinder head cover (A) with a new gasket (B).

Hyundai Venue. Cylinder Head Cover. Repair procedures

Hyundai Venue. Cylinder Head Cover. Repair procedures   
•
Do not reuse the disassembled gasket.
2.
Tighten the cylinder head cover bolts (A) with the order and steps.
Tightening torque
1st step:
3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)
2nd step:
7.8 - 9.8 N.m (0.8 - 1.0 kgf.m, 5.8 - 7.2 lb-ft)

Hyundai Venue. Cylinder Head Cover. Repair procedures
3.
Install the ignition coil.
(Refer to Engine Eletrical System - "Ignition Coil")
4.
Disconnect the OCV valve connector and then remove the OCV (A).

Hyundai Venue. Cylinder Head Cover. Repair procedures
5.
Connect the PCV hose (A).

Hyundai Venue. Cylinder Head Cover. Repair procedures
6.
Connect the ignition coil connector (A) and breather hose (B).

Hyundai Venue. Cylinder Head Cover. Repair procedures
7.
Connect the battery negative terminal.
8.
Install the engine cover.

    Components 1. Cylinder head cover 2. Cylinder head cover gasket

    Components 1. Exhaust camshaft 2. Intake camshaft 3. Exhaust CVVT 4. Intake CVVT 5. Camshaft bearing cap 6.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: A/C Pressure Transducer. Description and operation

    Description The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by operating it high speed or low speed.

    Hyundai Venue (QX) (2020-2026) Service Manual: PTC Heater. Repair procedures

    Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0148